Publicidad
Idiomas disponibles
Idiomas disponibles
PRODUCT SPECIFICATION
The cordless polisher is a universal, portable tool which does not require an external power source, designed for DIY enthusiasts
to polish and, to a lesser extent, grind surfaces made of diff erent materials with abrasive paper. Its specifi c advantages will be
appreciated by DIY enthusiasts performing various assembly and fi nishing works. As the proper use of the power tool is required
for the correct, reliable and safe operation please:
Read the entire instructions manual before the fi rst use of the tool and keep it for future reference.
The manufacturer shall not be held liable for any damage resulting from failure to observe the safety regulations and recommen-
dations specifi ed in this manual.
EQUIPMENT
The product is supplied complete and does not require assembly. The product comes with a sponge polishing pad and a wrench
for removing the disc. The YT-82924 article is equipped with a battery and a dedicated charger. The article YT-82925 is not sup-
plied with a battery and charger.
TECHNICAL DATA
Parameter
Catalogue No.
Operating voltage
Revolutions (idle speed)
Noise level
- sound pressure
- power L
WA
Protection rating
Insulation class
Vibration level
Weight
Tool chuck
Maximum grinding disc diameter
Battery type
Battery capacity
Charger*
Input voltage
Mains frequency
Output voltage
Output current
Rated power
Charging time**
* only for models equipped with a battery and charger
** the specifi ed charging time applies only to the battery with the capacity listed in the table
The declared noise emission value has been measured using the standard test method and can be used to compare one tool to
another. The declared noise emission value can be used in the preliminary exposure assessment.
The declared total vibration value has been measured using the standard test method and can be used to compare one tool to
another. The declared total vibration value can be used in the initial exposure assessment.
Caution! The vibration emission during tool operation may diff er from the declared value, depending on the manner the tool is
used.
Caution! Safety measures to protect the operator, which are based on an assessment of exposure under actual conditions of
use (including all parts of the work cycle, such as the time when the tool is switched off or idle and the activation time), must be
specifi ed.
GENERAL WARNINGS FOR THE SAFETY OF POWER TOOLS
Warning! Read all safety warnings, illustrations and specifi cations provided with this power tool. Failure to do so may
result in electric shock, fi re or serious injury.
O R I G I N A L
12
EN
Unit
[V DC]
[min
]
-1
[dB]
[dB]
[m/s
2
]
[kg]
['']
[mm]
[Ah]
[V~]
[Hz]
[V DC]
[A]
[W]
[h]
I N S T R U C T I O N S
Value
YT-82924, YT-82925
18
2100 – 5000
75.0 ± 3.0
86.0 ± 3.0
IP20
III
4.56 ± 1.5
2.9
M8
125
Li-ion
1.5
220 – 240
50 / 60
21
2
60
3
Publicidad
