Product Overview; Product Accessories; Technical Data - YATO YT-82360 Manual Original

PRODUCT OVERVIEW

The gypsum sander is a power tool using sanding discs to sand large, fl at surfaces. The long handle allows sanding walls without
using any platforms. The sander features a system for the extraction of dust generated during works, and a hose to connect the unit
to a vacuum device, which reduces the amount of dust in the work area. The battery power supply allows working in places without
easy mains access. Proper, reliable and safe operation of the power tool depends on appropriate use, that is why you should:
Read the entire instructions manual before the fi rst use of the tool and keep it for future reference.
The supplier shall not be liable for any damage resulting from failure to comply with the safety instructions and recommendations
specifi ed in this instructions manual.

PRODUCT ACCESSORIES

The tool comes complete but requires some assembly work. The sander comes with sandpaper sheets, dust bag hose and handle
extension arm. The YT-82360 article is equipped with a battery and a dedicated charger. The YT-82361 article is not supplied with
a battery and charger.

TECHNICAL DATA

Parameter
Catalogue No.
Rated voltage
Rated rpm
Spindle size
Disc fi xing ring diameter
Sanding disc diameter
Weight
Noise level
- sound pressure L ± K
pA pA
- power L ± K
wA wA
Vibration level ± K
ah,AG
Insulation class
Protection rating
Battery type
Battery capacity*
Charger*
Input voltage
Mains frequency
Output voltage
Output current
Rated power
Charging time**
* only for models equipped with a battery and charger
** the specifi ed charging time applies only to the battery with the capacity listed in the table
The declared noise emission value has been measured using the standard test method and can be used to compare one tool to
another. The declared noise emission value can be used in the preliminary exposure assessment.
The declared total vibration value has been measured using the standard test method and can be used to compare one tool to
another. The declared total vibration value can be used in the initial exposure assessment.
Caution! The vibration emission during tool operation may diff er from the declared value, depending on the manner the tool is used.
Caution! Safety measures to protect the operator, which are based on an assessment of exposure under actual conditions of use
(including all parts of the work cycle, such as the time when the tool is switched off or idle and the activation time), must be specifi ed.
GENERAL WARNINGS FOR THE SAFETY OF POWER TOOLS
Warning! Read all safety warnings, illustrations and specifi cations provided with this power tool. Failure to do so may
result in electric shock, fi re or serious injury.
O R I G I N A L
14
EN
Unit
[V DC]
[min -1 ]
[mm]
[mm]
[kg]
[dB (A)]
[dB (A)]
[m/s ]
2
[Ah]
[V~]
[Hz]
[V DC]
[A]
[W]
[h]
I N S T R U C T I O N S
Value
YT-82360, YT-82361
18
600 – 1200
M6
215
225/215/210
3.0
87.0 ± 3.0
95.0 ± 3.0
3.18 ± 1.5
III
IP20
Li-ion
4
220 – 240
50 / 60
21
2
60
3