English
► Insert a felling wedge. The felling wedge must
match the tree diameter and the width of the
felling cut.
► Shout a warning.
► With outstretched arms, cut through the stabi‐
lizing strap horizontally from outside at the
same level as the felling cut.
The tree falls.
11.6.9
Felling a small diameter leaner
A leaner is felled with a felling cut and holding
strap. This felling cut must be performed if the
tree diameter is less than the guide bar's length.
► Shout a warning.
► Plunge the guide bar into the felling cut until it
is visible at the other side of the trunk,
11.6.5.
► Enlarge felling cut in direction of hinge.
► Enlarge felling cut in direction of holding strap.
► Shout a warning.
► With arms outstretched, cut through the hold‐
ing strap from outside at a downward angle.
The tree falls.
52
11.6.10
A leaner is felled with a felling cut and holding
strap. This felling cut must be performed if the
6.
tree diameter is greater than the guide bar's
length.
► Shout a warning.
► Apply the spiked bumper behind the holding
► Hold the saw horizontally and swing it into the
► Enlarge felling cut in direction of hinge.
► Enlarge felling cut in direction of holding strap.
► Move to the other side of the tree.
► Apply the spiked bumper behind the hinge at
1.
2.
► Hold the saw horizontally and swing it into the
► Enlarge felling cut in direction of hinge.
► Enlarge felling cut in direction of holding strap.
► Shout a warning.
► With arms outstretched, cut through the hold‐
12 After Finishing Work
12.1
► Switch off chainsaw, engage the chain brake
► If the chainsaw is wet: Allow the chainsaw to
► If the battery is wet: Leave the battery to dry.
► Clean the chainsaw.
► Cleaning the Guide Bar and Saw Chain.
Felling a large diameter leaner
1.
2.
3.
strap at the same height as the felling cut and
use it as a pivot.
felling cut as far as possible.
the same height as the felling cut and use it as
a pivot.
felling cut as far as possible.
ing strap from outside at a downward angle.
The tree falls.
After Finishing Work
and remove the battery.
dry.
12 After Finishing Work
5.
6.
4.
0458-009-9801-A