Beurer BARBERS CORNER HR 4000 Instrucciones De Uso página 26

6. When you are finished, press the ON/OFF but-
ton to switch off the device.
Note
If you wish to cut your beard very short (less than 2.5 mm), you can
use the device without a comb attachment.
Shaving/trimming precise contours
With the comb attachment for the slim contour blade you can
shave/trim particularly precise contours (for example for the
sideburns).
1. The comb attachment for the slim contour
blade can only be used with the slim contour
blade attachment. To do this, attach the slim
contour blade to the device.
2. Now place the comb attachment for the slim
contour blade on the slim contour blade attach-
ment .
3. Select your desired length (1, 3, 5 mm) using
the slider on the comb attachment for the slim
contour blade.
4. Press the ON/OFF button
device.
5. Position the edge of the comb attachment for
the slim contour blade against the desired area
and move the device downwards as shown in
the adjacent image.
6. When you are finished, press the ON/OFF button
off the device.
9. Cleaning and maintenance
Clean the device
WARNING
• Always pull the mains adapter out of the socket before cleaning the
device. Risk of electric shock! Before cleaning, always ensure that
the device is switched off.
• Remove the comb attachments before cleaning.
• Only clean the housing of the device with a soft cloth dampened
with warm water or the cleaning brush supplied.
• Do not clean the device with highly flammable liquids. Risk of fire!
• Do not clean the device in the dishwasher.
• Clean the comb attachments as well as the shaver unit and the slim
contour blade after each use to prevent lots of hair getting jammed
inside, which could otherwise impede flawless operation.
• Do not use any aggressive, caustic, abrasive or corrosive cleaning
products or hard brushes.
to switch on the
26
to switch