Publicidad
Idiomas disponibles
Idiomas disponibles
|
CAUTION
This product is not suited for use with fluids intended for human consumption or fluids containing water. Materials of construction are not food
grade. Water will cause rust and corrosion in the pump housing. If water enters the pump, flush immediately with a petroleum product (gasoline,
diesel, kerosene, etc.) to eradicate residual water.
NOTICE
A Fill‑Rite filter should be used on the pump outlet to ensure no foreign material is transferred to the fuel tank. Foreign material can damage the
equipment being fueled.
Fueling Safety
DANGER
Fumes accumulated while fueling create an Explosive Atmosphere. It is CRITICAL that all possible sources of ignition be removed to a
safe distance or extinguished. Sources of ignition would include (but not limited to) open flames, cigarettes, static discharge, or electrical
connections that can create a spark. Explosion, fire, and severe injury or death will occur if the explosive vapors are ignited.
As a tank is being filled, air is displaced and exits via the fuel tank vent creating fumes, which when accumulated create an Explosive Atmosphere. To avoid possible explosion of
accumulated vapors, it is critical to keep possible sources of spark / ignition at safe distances from the fuel vapors.
The accompanying diagram shows minimum safe distances between the storage tank, dispenser, and power source.
WARNING
static electric spark can occur when filling
portable containers sitting on truck bed liners, or
on any vehicle's carpeting or floor matting. This
spark will explosively ignite a gasoline vapor fire
and cause SERIOUS INJURY or DEATH.
Installation
NX25‑120 and NX25‑240 pumps are designed to offer several different mounting
configurations. It can be mounted on a skid tank using the tank adapter supplied with
the pump (see attached diagrams), or mounted on a concrete island using an optional
pedestal adapter (model FRPA125 is available through your Fill‑Rite distributor).
Regardless of mounting style, all tanks must be properly vented.
CAUTION
Do not use check valves or foot valves unless they
have a proper pressure relief valve built into them.
Note that check valves will reduce rate of flow.
Nozzle Boot Installation
Install the nozzle boot using the supplied attaching bolt. Note that the bolt is inserted
through the hole closest to the nozzle opening, and the boot is then positioned so the peg
on the pump mounting surface inserts in the top second hole of the boot. This allows for
correct alignment of the nozzle when inserted into the boot.
fillrite.com
NX25-120 & NX25-240 SERIES AC FUEL TRANSFER PUMPS
• STATIC ELECTRIC SPARK EXPLOSION
HAZARD.
• NEVER fill portable containers that are in
or on vehicles.
• ALWAYS PLACE CONTAINERS ON GROUND.
• Keep nozzle in contact with container while
filling.
Mounting peg
Mounting bolt
INSTALLATION AND OPERATION MANUAL
MINIMUM SAFE DISTANCES ON
ABOVE GROUND STORAGE TANK
REFER TO NFPA 30A
Side View
20' [6 m]
Front View
20' [6 m]
Foot Mount Installation
The mounting foot is bolted to the bottom of the pump using the four supplied socket head
cap screws. Mount the foot with the bolt flanges inboard of the mounts on the pump as
illustrated. Torque to 50 in‑lbs with 4mm hex key.
Dispenser
Storage
Tank
18" [0.5 m]
20' [6 m]
18" [0.5 m]
20' [6 m]
4
Publicidad
