Publicidad
Idiomas disponibles
Idiomas disponibles
|
Operating Instructions
NOTICE
The motor has power at all times when connected to a power source. The switch does not apply or interrupt power to the motor. High voltage may
still be present inside the pump after power is removed.
CAUTION
Always keep the nozzle in contact with the container being filled during the filling process to minimize the possibility of static electricity build up.
1. Remove dispensing nozzle from nozzle boot.
2. Move the switch lever to the "ON" (raised) position to start the motor. The pump should
start and settle into a slow idle.
3. Insert the dispensing nozzle into the container to be filled.
4. Operate the nozzle to dispense fluid; release nozzle when the desired amount of fluid
has been dispensed.
5. Move switch lever to the "OFF" (lowered) position to stop the motor.
6. Remove the dispensing nozzle from the container being filled and store it
in the nozzle boot.
Pad Locking
Your Fill‑Rite nozzle can be pad locked to the pump for added security. With the pump
turned off, and the nozzle in the stored position, a pad lock can be inserted through the
locking link and the nozzle handle opening. This configuration prevents the nozzle from
being removed from the nozzle boot.
The locking link is located on the nozzle side of the pump, and can be pivoted into
position to work with the nozzle listed on the barrel label of your NX25‑120 or NX25‑240
pump. Use the appropriate position and hole to lock your nozzle securely to your
NX25‑120 or NX25‑240 series pump.
fillrite.com
NX25-120 & NX25-240 SERIES AC FUEL TRANSFER PUMPS
INSTALLATION AND OPERATION MANUAL
ON
OFF
7
Publicidad
