ZGR SOLAR STR 250
Ensure that the DC voltage does NOT exceed 1000 V, higher input voltages can cause permanent
damage to the equipment or major damage.
It must be covered by an element that protects the equipment from the effects of sunlight, otherwise there
is a risk of High Voltage due to sun exposure.
Should you have any problems with the contents of this manual, you must ask ZIGOR for assistance.
1.2
Storage precautions
Proper storage is required if the inverter is not installed immediately.The store where the inverters are kept must
protect the material from the elements, risk of flooding or contact with water.
Store the inverter in the original packing case.
The storage temperature must be always between -40° C and +70° C, and the storage relative humidity must be
always between 0 and 95 % , non-condensing.
In case of stacking storage, the number of stacking layers should never exceed the limit marked on the outer side
of the packing case.
The material shall be protected from any risk of overheating due to exposure to direct sunlight.
The packing case should be upright.
If the inverter has been stored more than half a year, the qualiûed personnel should thoroughly check and test it
before using.
WARNING
Any failure to respect these precautions may render the product warranty null and void.
1.3
Environmental precautions
Dispose of the packaging in an ecological way: ZIGOR, based on the exceptions detailed
in the First Additional Provision of Law 11/1997 on commercial or industrial packaging,
informs that the final holder of the waste of used containers and packaging, as responsible
for them, you must deliver them in appropriate conditions for reuse, to an authorized
recuperator, recycler or re-valuer.
The subsets of the system are recyclable products and cannot be treated as household / municipal waste at
the end of its useful life.
To preserve the environment, manage them in accordance with current environmental regulations and
requirements in each country or community. In case of doubt, consult the manufacturer.
Correct product disposal: This electrical-electronic device (AEE) is marked with the symbol
of compliance with the European Directive 2012/19 / EU (WEEE) regarding used electrical
and electronic equipment (Waste electrical and electronic equipment WEEE, RD 110/2015).
The Directive provides the general framework valid throughout the European Union for the
removal and reuse of waste from EEE.
To dispose of this product and ensure its proper management, follow the current local
environmental legislation and regulations. In this way it will contribute to conserve the
environment.
Operation manual
www.zigor.com
4