Sony UPA-P100MD Manual Del Usuario página 3

Using Back to Live
(With S-video (Y/C) Signals)
The Back to Live function can display still images for
a set length of time when they are captured. To use
Back to Live, it is necessary to connect the
UPA-P100MD to a monitor with the custom cable
mentioned above.
Notes
• The following procedure assumes that the video
device outputs S-video (Y/C) signals. Procedural
differences between S-video (Y/C) and video signals
are mentioned, as necessary.
• This function is not active when capturing video.
1
Connect a monitor to the UPA-P100MD as
described above.
Make sure that the monitor line is Line B.
Note
When the video device outputs video signals,
select Line A as the monitor line.
2
Access the configuration screen as described in
the UPA-P100MD User's Guide.
3
Select [A] for [Analog loopback port].
Note
When the video device outputs video signals,
select [B] for [Analog loopback port].
4
Specify a value between 0 and 10 seconds for
[Back to live delay (0-10)].
Note
To deactivate the Back to Live function, specify 0.
5
Click [Save Config].
The UPA-P100MD restarts.
6
When you are ready to capture still images, press
[1] on the RM-P110.
[Grabbing Image] appears on the RM-P110
display, the captured still image is displayed on
the
monitor for the set length of time, then it switches
back to the "live" display.
7
Capture other still images as necessary.
GB
3