Scheppach PL55 Traduccion Del Manual De Instrucciones Originale página 35

Plunge Cuts with guide rails
1. Set the saw on the guide rail at the marked cutting
point
2. Secure the rebound protection or fence (accesso-
ry not included) at the back and front cut points on
the guide rail.
3. Switch on the machine.
4. Press the saw down slowly to the set cut depth and
move this forward evenly on the rail up to the front
cutting point.
Tilt Protection
For miter cuts, it is advisable to install a tilt protection.
This prevents the machine from tilting to one side while
in an oblique position.
Injuries to the body or damage to the machine can be
avoided thereby.
When you are finished cutting
1. First turn the plunge saw off and then the dust ex-
tractor. The saw blade will continue to rotate for
some time.
2. Remove the cutting waste from the saw blade
when the saw blade returns to the resting position.
3. Disconnect the plunge saw from the power supply
by pulling the mains plug out of the socket.
4. Let the plunge saw cool off completely.
Removing jammed material
m Warning!
Incorrect handling of the plunge saw poses a risk of
serious injury.
• Immediately switch the plunge saw off and pull the
mains plug out of the socket if the saw blade catches
in the workpiece or any other blockages occur.
• Use protective gloves. Do not touch the saw blade
with your bare hands.
10. Transport
Always switch off the electric tool before transport and
disconnect it from the power supply.
To transport the electric tool, lift it by the Handle/hand
grip.
Protect the electric tool against impacts, shocks and
severe vibrations, e.g. during vehicular transport.
Secure the electric tool against toppling and slipping.
11. Cleaning and maintenance
m WARNING!
Prior to any adjustment, maintenance or service work
disconnect the mains power plug!
General maintenance tasks
• To ensure constant air circulation, always keep the
cooling openings in the housing unobstructed and
air accessible.
• Use an extractor on all the openings of the machine
to remove wood chips and splinters.
• Rub the device clean with a clean cloth or blow it off
with compressed air at low pressure.
• We recommend that you clean the device directly
after every use.
• Clean the device at regular intervals using a damp
cloth and a little soft soap. Do not use any cleaning
products or solvents; they could attack the plastic
parts of the device. Make sure that no water can
penetrate the device interior.
• Oil the rotating parts once monthly to extend the life
of the tool. Do not oil the motor.
Carbon brushes
• If excessive sparks are generated, have an electri-
cian check the carbon brushes.
m ATTENTION! The carbon brushes must be replaced
by an electrician exclusively.
m Warning!
Incorrect handling of the plunge saw poses a risk of
serious injury.
• Before cleaning or maintenance, switch the plunge
saw off and pull the mains plug out of the mains
socket.
• Wear suitable protective gloves when working on
the plunge saw.
• There are no parts that can be repaired by the user
inside this plunge saw. Never attempt to repair the
plunge saw yourself. Always contact a qualified
workshop for this.
m Warning!
The saw blade may become hot during operation, you
could burn yourself on it.
Always let the saw blade cool off completely before
cleaning.
www.scheppach.com GB | 35