Publicidad
Idiomas disponibles
Idiomas disponibles
Figure 3. Mounting the UPS
1 1 . . 3 3
M M o o u u n n t t i i n n g g t t h h e e E E B B M M t t o o t t h h e e D D I I N N R R a a i i l l
To Mount the BPDIN24XL EBM:
1.
Locate the top hook of the DIN rail mounting system on the unit with the unit slightly titled.
2.
Rotate the unit till the latch of the rail mount system snaps on to the bottom of the DIN rail and the unit
cannot be rotated any further.
3.
Shake the UPS slightly to ensure that it is secure.
4.
Check if the UPS is facing upright and not tilting downward.
5.
Add additional BPDIN24XL extended battery modules by following the above steps and ensure that each
EBMs are at a minimum distance of 0.39in (10mm) between each module. Up to four EBM modules can
be used per UPS.
Figure 4. Mounting the BPDIN24XL EBM
Hook to top of the DIN rail
Listen for a click to ensure the UPS is secured
to the DIN rail.
Hook to top of the DIN rail
Listen for a click to ensure the UPS is secured
to the DIN rail.
Eaton Din Rail UPS Quick Start Guide 934184—Rev A
Mounting the EBM to the DIN Rail
3
Publicidad
