Publicidad
Idiomas disponibles
Idiomas disponibles
Mounting the UPS to the DIN Rail
Figure 2. BPDIN24XL Features
1 1 . . 2 2
M M o o u u n n t t i i n n g g t t h h e e U U P P S S t t o o t t h h e e D D I I N N R R a a i i l l
The EATON DIN500AC and DIN850AC UPS can be mounted on "top hat" 35mm DIN rail in accordance with EN60715.
The DIN24240DC and DIN24480DC UPS can be mounted on a 35 mm DIN rail in accordance with EN60715.
For vertical mounting, the device should be installed with the input terminal block facing down.
To Mount the UPS:
1.
Locate the top hook of the DIN rail mounting system on the unit with the unit slightly titled.
2.
Rotate the unit till the latch of the rail mount system snaps on to the bottom of the DIN rail and the unit
cannot be rotated any further.
3.
Shake the UPS slightly to ensure that it is secure.
4.
Check if the UPS is facing upright and not tilting downward.
2
Eaton Din Rail UPS Quick Start Guide 934184—Rev A
[+] [-]
[+] [-]
Front of EBM
Front of EBM
Top of EBM
1 DC Terminals
2 DC Terminals
3 DIN Rail Clamp
[+] [-]
1
3
2
Publicidad
