Publicidad
Idiomas disponibles
Idiomas disponibles
Otherwise, the seal ring foam may be deformed and compromise the
quality of air suction
TECHNICAL DATA
Lithium battery: 7.4V, 2000mAh, 11.1Wh
•
•
Power: 80W
USB-C cord
•
Input voltage: DC5V, 1A
•
•
Battery duration: 80 sealed bags
Dimensions: 37.5x15x7cm
•
Net weight: 1055 g
•
Charging adapter
Input: AC 100-240V ~ 50-60Hz, 0.2A max
•
•
Output: DC 5V – 1.0A, 5W
TROUBLESHOOTING
COMMON FAULT
No reaction during vacuum
packing
No suction occurs
Impossible to seal after suction
.
CAUSE
There is no power
Incorrect operation
There is dirt on the sealing tape
and on the foam
There is dirt or liquid on the end
of the bag
The pressure does not reach the
pre-set level
The open end of the bag is wet or
sealing is poor
The sealing tape does not work
Poor sealing
The bag has leaks
SOLUTION
Check whether the battery is flat.
If so, recharge the appliance
1. Check that the top and bottom
lid are properly closed.
2. Check that the appliance and
container are properly connected
3. The open end of the bag must
be placed in the tray
Remove the dirt and clean
1. Make sure to use bags suitable
for vacuum packing
2. Check that the open end of the
bag is perfectly smooth, without
folds, without dirt, hard objects,
etc.
3. Check the bag for any leaks
1. Check the bag for any leaks.
2. Check whether the foam is
deformed or damaged.
3. Make sure the bag is in the
right position
Press button 3 Seal again.
Check whether the tape has
reached temperature. If not,
contact the after-sales service.
Check that the open end of the
bag is perfectly smooth, without
folds, without dirt, hard objects,
etc.
Check the bag for any leaks and
replace it with a new one.
25
Publicidad
