Descargar Imprimir esta página

Bimar HY-200J Folleto De Instrucciones página 15

Termoconvector

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

1.
Always unplug the appliance before
you assemble.
2.
Insert the wheels into the bottom part
of the supporting feet, and to be sure it
is tight enough.
3.
Place
the
position the feet near the end of the
base, making sure that the protrusion of
the head of the 2 screws coincides with
the round cavities of the feet.
4.
Fix each foot by the supplied screws,
screwing with a force just to lock them:
the feet must perpenticular to the body,
and the 4 wheel must be in adhesion to
floor surface.
USE
Before each use, verify that the unit is in good condition, the electric cord is not damaged, if
the power cord is damaged, it must be replaced by the manufacturer or a competent qualified
electrician or a person with similar qualifications, in order to avoid any risk.
The appliance can be adjusted as follows:
-Selector. Turn the relative knob (C) clockwise to select functions: 0= off,
(1000W),
= maximum (2000W).
- Room thermostat. Set (using relative knob B) the room temperature and start the appliance
in continuous mode until the set temperature is reached: if these drops, the appliance restarts
for the time necessary to re-establish the set value. If the knob is turned completely anti-
clockwise, the appliance remains off "-", if it is turned completely clockwise the maximum
temperature is set "+"; for intermediate values the temperature increases as the knob is
turned towards the Maximum position and vice versa.
The lamp (A) is on when the thermostat is active for the positions of the selectors (
and
), if it reaches the set temperature, the light goes out and turns back on as soon as it
decreases.
The appliance has an anti-tipping switch inside which allows it to function only when the
appliance is vertical, and switches it off if it tilts.
First use
Warning:run the appliance for at least a few hours to eliminate the "new smell" and any oil
residue from the manufacturing process.During this operation, ventilate the room well to
eliminate the "new smell" that is given off.
appliance
upside
down,
15
= minimum

Publicidad

loading

Este manual también es adecuado para:

Hc511