Metabo W 6-100 Instrucciones De Manejo página 18

ENGLISH
ENG
To switch on: Push the slide switch (4) forward.
For continuous activation, now tilt down-
wards until it engages.
To switch off: Press the rear end of the slide
switch (4) and release it.
8.2 Working instructions
Grinding:
Press down the machine evenly on the surface and
move back and forth so that the surface of the
workpiece does not become too hot.
Roughing: position the machine at an angle of
30° - 40° for the best working results.
Separating:
Always work against the run of the
disc (see illustration). Otherwise
there is the danger of the machine
kicking back from the cut out of
control. Guide the machine evenly at
a speed suitable for the material being processed.
Do not tilt, apply excessive force or sway from side
to side.
Sanding:
Press down the machine evenly on the surface and
move back and forth so that the surface of the
workpiece does not become too hot.
Wire brushing:
Press down the machine evenly.
9 Cleaning
Motor cleaning: blow compressed air through the
rear ventilation slots of the machine regularly,
frequently and thoroughly. Here, the machine must
be held firmly.
10 Accessories
Use only genuine Metabo accessories.
If you need any accessories, check with your
dealer.
For dealers to select the correct accessory, they
need to know the exact model designation of your
power tool.
See page 4.
A Roughing disc (always use with safety guard
attached)
B Louver disc (always use with safety guard
attached)
C Parting safety guard.
D Parting disc (always use with parting safety
guard attached)
E Diamond discs (always use with parting safety
guard attached)
18
F Hand guard (for attaching under the additional
side-mounted handle.)
G Extension piece (for working with supporting
discs. Increases the distance between the
spindle and the supporting disc by approx.
35 mm)
H Supporting disc for fibre discs (always attach
using the supporting disc clamping nut
supplied.) (always use with the hand guard
attached.)
I Fibre discs (always use with the hand guard
attached.)
J Semi-flexible sanding discs (for use with
elastic supporting disc 6.23279) (always use
with hand guard attached.)
K Sanding pad with Velcro (always use with the
hand guard attached.)
L Adhesive sanding disc (always use with the
hand guard attached.)
M Adhesive fleece (always use with the hand
guard attached.)
N Steel wire brushes (always use with the
hand guard attached.)
O Adjusting nut (7)
For a complete range of accessories, see
www.metabo.com or the main catalogue.
11 Repairs
Repairs to electrical tools must be carried out
by qualified electricians ONLY!
Any Metabo power tool in need of repair can be
sent to one of the addresses listed in the spare
parts list.
Please enclose a description of the fault with the
power tool.
12 Environmental Protection
The sanding dust generated may contain
hazardous materials: do not dispose of with the
household waste, but at a special collection point
for hazardous waste.
Metabo's packaging can be 100% recycled. Scrap
power tools and accessories contain large
amounts of valuable resources and plastics that
can be recycled.
Only for EU countries: Never dispose of
power tools in your household waste! In
accordance with European Guideline 2002/
96/EC on used electronic and electric equipment
and its implementation in national legal systems,
used power tools must be collected separately
and handed in for environmentally compatible
recycling.