Black and Decker BWDS Manual De Instrucciones página 12

SET UP & USE
5. Align the holes in the DIAGONAL SUPPORT RAIL, LB2-1 (UPPER LEFT
BACK VERTICAL POLE) and ANTI-TIP BRACKET as shown below. Insert 35M
(BUTTERFLY SCREW) into the ANTI-TIP BRACKET and insert all the way through
the DIAGONAL SUPPORT RAIL and LB2-1 (UPPER LEFT BACK VERTICAL
POLE).
Align the holes in the DIAGONAL SUPPORT RAIL, RB2-1 (UPPER RIGHT BACK
VERTICAL POLE) and ANTI-TIP BRACKET as shown. Insert 35M (BUTTERFLY
SCREW) into the ANTI-TIP BRACKET and insert all the way through the
DIAGONAL SUPPORT RAIL and RB2-1 (UPPER RIGHT BACK VERTICAL POLE).
Installation Sequence
Step1: Add Diagonal support rail.
Step2: Add Anti-tip brackets.
RB2-1
RB2-2
Page 12
LB2-1
Diagonal Support Rail.
Anti-tip brackets
Step3: Insert 35M screws.
LB2-1
LB2-2
Insert 35M screws
ANTI-TIP
BRACKET
35M