Publicidad
Idiomas disponibles
Idiomas disponibles
SET UP & USE
3. Attach REINFORCING BARS with caps on the ends, to the top and bottom of the
left BACK pole. Attach the REINFORCING BAR without caps to the top of the LF1-1
as shown below.
Attach one side of a REINFORCING BAR to LB2-1 . Align the holes and Insert 45L
(BUTTERFLY SCREW) through LB2-1 first and then through the reinforcing bar.
Attach one side of a REINFORCING BAR to LF1-1 . Align the holes and Insert 45L
(BUTTERFLY SCREW) through LF1-1 first and then through the reinforcing bar.
Attach one side of the remaining REINFORCING BAR to LB2-2 . Align the holes
and Insert 45L (BUTTERFLY SCREW) through LB2-2 first and then through the
reinforcing bar.
45L
NOTE: The wings of 45L screw must keep vertical rather than horizontal so it does
not obstruct the installation of the DRYER SUPPORT.
CORRECT
REINFORCING BAR
WITHOUT CAPS
LF1-1
REINFORCING BAR
WITH CAPS
LB2-2
REINFORCING BAR
WITH CAPS
INCORRECT
45L
LB2-1
45L
Page 9
Publicidad
