Black and Decker BWDS Manual De Instrucciones página 14

SET UP & USE
7. Tighten all the BUTTERFLY SCREWS and move the stand to where you intend to
attach it to the wall.
8. Mark the position on the wall where the holes of the ANTI-TIP BRACKET will
connect to the wall.
WARNING: To reduce the likelihood of injury or property damage, the anti tip
feature must be properly installed and utilized.
WARNING:
Suitable lag type screws (included) will need to be used to properly anchor the
washer dryer stand to a rigid framing member. Rigid framing members could include
wood or metal studs and concrete blocks. If screwed into a wood framing member
using lag screws with a minimum diameter of 1/4" and 1-1/2" in length, mounting one
bracket on a wall stud will be sufficient.
Before drilling or screwing, verify that there are no electric cables, plumbing pipes or
other potential hazards behind the wall where the lag screws are being installed.
ANTI-TIP BRACKETS
Page 14