Publicidad
Idiomas disponibles
Idiomas disponibles
SET UP & USE
ASSEMBLY INSTRUCTIONS
1. Using the diagram below as reference to position the
poles, INSERT LB2-2 (LOWER LEFT BACK VERTICAL
POLE) and LF1-2 (LOWER LEFT FRONT VERTICAL
POLE) into L-BP LEFT BASE. The base of the poles
should be positioned between the L-BP slots and aligned
with the holes.
Use 25S (BUTTERFLY SCREW) to secure on each side.
They should be inserted from the outside of L-BP and
inserted fully through the holes of the poles to secure.
NOTE: Follow the same steps to assemble the right side.
Closeup of LF1-2 and
LB2-2 being inserted into
L-BP . Make sure holes are
aligned when inserted.
L-BP
2. Insert LB2-1 (UPPER LEFT BACK VERTICAL POLE) into LB2-2 (LOWER LEFT
BACK VERTICAL POLE).
Insert LF1-1 (UPPER LEFT FRONT VERTICAL POLE) into LF1-2 (LOWER LEFT
FRONT VERTICAL POLE).
LF1-2
LB2-2
25S
LB2-1
LB2-2
LF1-2
LB2-2
L-BP
LF1-1
LF1-2
25S
Page 7
Publicidad
