Black and Decker BWDS Manual De Instrucciones página 8

SET UP & USE
Line up the holes of one side of a SUPPORT RAIL, then the CONNECTING RAIL with
the holes on the exterior side of LF1-1 (UPPER LEFT FRONT VERTICAL POLE)
and LB2-1 (UPPER LEFT BACK VERTICAL POLE). Secure with 25S (BUTTERFLY
SCREW).
LB2-1
Connecting Rail
25S
25S
Line up the middle hole of the SUPPORT RAIL with the hole on the outside of LF1-2
(LOWER LEFT FRONT VERTICAL POLE), Secure with 25S (BUTTERFLY SCREW).
Support Rail
25S
Line up the last hole of the SUPPORT RAIL with the hole on the outside of L-BP
(LEFT BASE), Secure with 15S (BUTTERFLY SCREW).
NOTE: Follow the same steps to assemble the right side.
Support Rail
15S
Page 8
LF1-1
Support Rail
LF1-2
L-BP