Publicidad
Idiomas disponibles
Idiomas disponibles
Table 1
MANUFACTURER'S GUIDE AND DECLARATION - ELECTROMAGNETIC EMISSIONS
The scooters are intended for use in the following electromagnetic conditions.
EMISSION TESTS
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage flutter/flicker
IEC 61000-3-3
Table 2
MANUFACTURER'S GUIDE AND DECLARATION - ELECTROMAGNETIC EMISSIONS
The scooters are intended for use in the following electromagnetic conditions.
Immunity tests
Electrostatic discharge
(ESD) IEC 61000-4-2
Electrical Fast Transient/
Burst Immunity
IEC 61000-4-4
Over voltages IEC
61000-4-5
Voltage drop outs, brief
interruptions and variations
of voltage on the power
supply lines. IEC 61000-4-11
The client or user must ensure that it is used in these conditions.
CONFORMITY
Not applicable
Conforming
The client or user must ensure that it is used in these conditions.
Test level IEC 60601
± 6 kV contact
± 8 kV air
±2 kV for power lines
±1 kV differential mode
±2 kV common mode
<5% UT
(>95% UT drop out)
for 0.5 cycles
40% UT
(60% UT drop out)
for 5 cycles
70% UT
(30% UT drop out)
for 25 cycles
<5% UT
(>95% UT drop out) for 5 s.
The scooters use RF energy only for
internal functions and for charging
Group 1
Class B
in all buildings, including the home
Conformity level
± 6 kV contact
± 8 kV air
±2 kV for power lines
±1 kV differential mode
±2 kV common mode
<5% UT
(>95% UT drop out)
for 0.5 cycles
40% UT
(60% UT drop out)
for 5 cycles
70% UT
(30% UT drop out)
for 25 cycles
<5% UT
(>95% UT drop
out) for 5 s.
ELECTROMAGNETIC
ENVIRONMENT – GUIDE
the battery. Their RF emissions
are therefore very low and in all
likelihood do not interfere with
nearby electronic equipment.
The scooters are suitable for use
and buildings connected directly
to the low voltage public power
grid for residential applications.
Electromagnetic
environment – guide
Information for using the
device and charging the
battery. The floor must be
wood, concrete or ceramic.
If the floor is covered
with a synthetic material,
the relative humidity
must be at least 30%.
The quality of the mains
supply must be that of
a typical commercial or
hospital environment.
The quality of the mains
supply must be that of
a typical commercial or
hospital environment.
The quality of the mains
supply must be that of a
typical commercial hospital
when charging the battery.
7
Publicidad
