Publicidad
Idiomas disponibles
Idiomas disponibles
R R e e m m o o v v i i n n g g t t h h e e U U P P S S f f r r o o m m t t h h e e D D I I N N R R a a i i l l
1.
Turn off the UPS and ensure that mains power is disconnected.
2.
Disconnect any wiring that is connected to the UPS.
3.
Pull down the on the DIN rail clamp with a flathead screwdriver or tool to release the clamp.
4.
Tilt the UPS slightly and then up to remove from the DIN rail.
Figure 3. Remove UPS From DIN Rail
Hook to top of the DIN rail
Pull down on DIN rail clamp to release
Eaton Din Rail UPS Quick Start Guide 934183—Rev A
Mounting the UPS to the DIN Rail
3
Publicidad
