Vaillant aroSTOR VWL B 270/5 Instrucciones De Instalación Y Mantenimiento página 65

3.4 CE marking
The CE marking shows that the products comply with the
basic requirements of the applicable directives as stated on
the declaration of conformity.
The declaration of conformity can be viewed at the manufac-
turer's site.
4 Set-up
4.1 Transporting the product to the installation
site
When being transported, the product must ideally be in a
vertical position. It must only be placed in a horizontal posi-
tion at the front, as specified on the packaging, if the height
of the vehicle is lower than the height of the product.
4.2 Carrying the product
Caution.
Risk of material damage caused by incor-
rect handling.
The product's upper covering hood is not
designed for loading and must not be used
for storage.
▶
Do not lift the product by the top covering
hood when transporting it.
8000015884_00 Installation and maintenance instructions
Warning.
Risk of injury from lifting a heavy weight.
Lifting weights that are too heavy may cause
injury to the spine, for example.
▶
When transporting the product, lift it with
the help of a second person.
▶
Observe the product weight stated in the
technical data.
▶
When transporting heavy loads, observe
the applicable directives and regulations.
1. Transport the product to the installation site using a
forklift truck or pallet truck.
2. Transport the product in the upright position only.
Condition: Transport the product to the final installation site in the transport-
ation bag supplied.
▶
Fully open out the transportation bag and lay it on the
ground.
▶
Using a rocking and turning motion, "walk" the product to
the centre of the transportation bag.
▶
Lift up the handles of the transportation bag to draw in
the sides of the transportation bag.
Note
Keep the transportation bag away from chil-
dren in order to prevent the risk of suffocation.
Condition: Transport the product to the final installation site using a hand
truck.
▶
Secure the product using a strap.
▶
In order to avoid scratches and damage, protect the
sides of the product that come into contact with the hand
truck.
4.3 Unpacking the product
1. Remove the straps.
2. Pull the cardboard box up and off.
3. Remove the two cardboard rings from around the
product.
4. Remove the cardboard box transport protection at the
compressor, as described on the sticker on the cover-
ing hood.
5. Remove the protective film.
6. Remove the accessory pack from the transportation
bag.
7. Remove the screw that is securing the product to the
pallet from the underside of the pallet without tilting the
product.
8. Ensure that nobody holds up or leans against the
product.
65