Publicidad
Idiomas disponibles
Idiomas disponibles
III.2 ASSEMBLING BEFORE USE
1. Connect Charging base and Adaptor
Turn the charging base over and remove the plastic cover. Connect the adapter's joint with the port
inside the charging base, then close the plastic cover and plug the adapter into socket,the indicator light
will shine green light it connects well with power.
Note:
If the cord length is too long, please wrapped it around the two pillars.
Do not leave gap between charging base and wall, leave at least 0.5m space in left and right and
keep at least 1.5m blank area in front.
Do not move the charging base during cleaning, otherwise the robot can not find it correctly.
Please avoid the charging base facing sunlight directly, as the direct sunlight may interfere with the
recharging signal and causes the robot unable to return back to the Charging base automatically.
2. Installation of side brushes
The left brush and right brush are different. On the leg of
brush you can find a letter "R" or "L", and on the
corresponding position of the robot bottom you can also find
"R" and "L".
Install the left side brush(L) and the right side brush(R) correspondingly to L and R on the robot
bottom by pressing them.
3.
Turn on the robot and charge power
Long press the power button
robot, then press the charging button
back the Charging base for power charging automatically.
Note: If the robot can not be powered on, it has no power.
Please put the robot on charging base till the indicator
light flashes light. After a few minutes of charging, you can
turn it on by long press the power button for 3s.
III.3 APPLICATION CONNECTION AND SHARE
Each the robot can only connect with one smart phone(Host phone). For multiple people use,the Host
phone need share it to others(See local 4)
for 3s to power on the
, the robot will go
41
Power button
Charging button
Publicidad
