Publicidad
Idiomas disponibles
Idiomas disponibles
speaker
Robot power
consumption
The robot does not
finish clean, and
automatically
returns to the
charging base
Remote control fails
The display content
of the application is
delayed
The robot has
finished charging,
but the blue light is
still flashing
The robot collides
with objects when
cleaning
Short working time,
serious battery
consumption
The robot does not
speak
The LED lights of the
two buttons does
not turn on
The robot is quite
noisy
V.2 Replacement recommendations for accessories
1) The following spare parts are subject to wears or consumables according to the use environment
The robot is always connected to the Wifi device (router), it will consume the
power, please keep it connected to the charging base when not to Use.
1. When the power is lower than 15%, the robot automatically returns to the
charging base.
Please restart clean after charging finish.
2. It is only used for ordinary indoor use, please do not use it outdoors or in
commercial places
3. The Sensor area of the robot are dirty, please clean
4. Sunshine interfere the robot working, please close the curtains
5. Robots are not suitable for working on Pure white carpets, please avoid
6. The robot is trapped in a small place, and the cleaning is completed by default.
Please pause it and move to an open place ， try again.
7. The robot is suspended, please clean the foreign objects and place it on flat
horizontal surface
1. The remote control battery is low, replace with new batteries and install them
correctly
2. The robot is off, please turn it on
3. The distance is too far, make sure the distance is within 10m
4. The remote control and robot sensor are dirty, please clean
1. Refresh the application, Quit and log in again
2. There may be a network delay, please check your network or do it later
1. After the app shows 100% power, the robot will slowly charge until it is
saturated, which takes about 30 minutes, and then the indicator will go out.
2. The robot will automatically charge after the battery is 90% low until it is
saturated, and then the indicator light will go out.
1. The Sensor area of the robot are dirty, please clean
2. Check if the Bumper is stuck，Normal state can sliding backwards and
forwards
3. Objects that are too small (less than 3cm) sometimes cannot be detected by
the robot, please remove them.
1. Please check whether the battery is sufficient before cleaning
2. Depending on environments and cleaning modes used. After the battery is fully
charged, the following total time for cleaning on the Tiled floor is :
Low suction:200-230 minutes
Maybe you have selected quiet mode with remote control, please set the robot
back to sound mode with remote control
Maybe you have turned them off with remote control, please use the remote
control to turn them on
You can select lower suction power level with remote control or by application.
60
Publicidad
