Mazda 0000-8E-R06A Instrucciones De Instalación página 3

01
Remove Plastic Underbody
• Remove two plastic fasteners on plastic underbody panel.
• Remove and discard plastic underbody panel.
02
Attach Rear Bumper Fascia Template
• Review trim template and center onto rear bumper surface
and align bottom edge of template with bottom edge of fascia.
• Note: There is a centerline on the inside of the bumper.
• Apply tape onto specified locations.
06/14/18
Page 3 of 10
Tools Needed:
Flathead
screwdriver
Tools Needed:
Tape
0000-8E-R06A Rev E