Mazda 0000-8E-R06A Instrucciones De Instalación página 6

Loosely Bolt Driver Side Plate
• Position side plate onto driver side rail and use the M12 bolts, conical washers,
flat washers and a handle nut to assemble.
• Note: Handle nut will not be used on driver side of diesel vehicles.
• Note: Be sure side plates are positioned so they angle towards the center
of the vehicle.
Driver side rail
Plates angle inward
Loosely Bolt Passenger Side Plate
• Position the passenger side plate in the same configuration as stated above.
• Note: Insert handle nuts into access holes under frame rails as shown in figure C.
Passenger side rail
06/14/18
C
Page 6 of 10 0000-8E-R06A Rev E