Mazda 0000-8E-R06A Instrucciones De Instalación página 4

03
Trim Bumper Fascia
• Use saw to cut template around outside
border along dotted lines.
• Use file to remove burrs and rough edges.
04
Driver Side Frame Rail (Diesel Models Only)
A) Puncture and remove protective tape on outside of
the driver side rail.
B) Use needle nose pliers to remove plastic frame plug (discard).
C) Disconnect electrical wire harness retainer clip with flathead
screwdriver. Be careful not to damage wire harness.
Driver side rail
06/14/18
A
Page 4 of 10
Tools Needed:
Safety
goggles
B
Saw
File
Tools Needed:
Flathead Needle nose
screwdriver pliers
A
0000-8E-R06A Rev E