Publicidad
Idiomas disponibles
Idiomas disponibles
SAFETY INFORMATION
• If the workpiece or cutting wheel becomes jammed or bogged down, turn tile saw
"OFF" by releasing the switch. Wait for all moving parts to stop and disconnect the
battery from the tile saw, then work to free the jammed material. Continued sawing with
jammed workpiece could cause loss of control or damage to tile saw.
• Feed work into cutting wheel against the direction of rotation of the wheel only.
• Do not reach in back of the cutting wheel with either hand to hold down or support the
workpiece, remove scraps, or for any other reason. The proximity of the spinning cutting
wheel to your hand may not be obvious and you may be seriously injured.
• DO NOT remove small pieces of cut-off material that may become trapped inside the
blade guard while the saw is running. This could endanger your hands or cause a kick
back. Turn saw "OFF" and wait until cutting wheel stops.
• Dull, gummy or improperly sharpened or set cutting tools can cause material to
stick, jam, stall the saw, or kickback at the operator. Minimize potential injury by proper
cutting tool and machine maintenance. NEVER ATTEMPT TO FREE A STALLED CUTTING
WHEEL WITHOUT FIRST TURNING THE SAW OFF.
• Empty water from water reservoir before transporting. Water left in the water reservoir
can splash into electrical components.
PREPARATION
Know Your Tabletop Tile Saw
Before attempting to use the tile saw, familiarize yourself with all of its operating features and
safety requirements.
WARNING
• Do not allow familiarity with the tile saw to cause carelessness. Remember that one
careless moment is enough to cause severe injury. Before attempting to use any tool, be
sure to become familiar with all of the operating features and safety instructions.
• Do not attempt to modify this tool or create accessories not recommended for use with this
tool. Any such alteration or modification is misuse and could result in a hazardous condition
leading to possible serious personal injury.
11
Publicidad
