Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
9. Water Reservoir Plug Installation
The water reservoir plug (Q) features an overflow
drain – an outlet on the head, which can prevent
overfilling. Do not block this outlet.
Before filling the reservoir with water, firmly push
and twist the water reservoir plug (Q) into the hole
on the bottom of the reservoir (F).
To drain the water, pull he water reservoir plug (Q)
out.
10. Filling the Water Reservoir
The water reservoir (F) must be filled at least to
the "MIN" fill line and should not be filled past the
"MAX" fill line. Check the water level periodically
and refill as needed.
NOTICE: Never turn the saw on without enough
water in the reservoir. Add water if you notice saw
dust in the air. Lack of water may damage the
cutting wheel.
a. Remove the battery pack and slide the sliding
table (B) aside.
NOTICE: Make sure the water reservoir plug (Q)
is installed to prevent overfilling. Refer to chapter
"Water Reservoir Plug Installation" earlier.
b. Fill the water reservoir (F) with clean tap water to fill line. Do not add chemicals or
detergents to the water.
c.
Close the sliding table.
9
Q
10
18
Publicidad
