Sammic OS-140P Manual De Instrucciones página 35

4.8 SETUP MENU
Config Press >
Reset T Filters
By pass funct
Select
CUSTOMER
Select Funct.
Select K
convrs
Select Hours
funct
Select
language
To access the advanced system functions and set-up area, shut down and
disconnect the appliance.
cord.
After a few seconds, the system will ask you to press the button
confirm access to the set-up menu and advanced functions.
press > Reset
T
By pass act
OS-140P
Funct no limit
K Convrs
0060nvrs
Hours funct
0070funz
Spanish
Then press the button
This resets the filter operating hours.
with and confirm with
You can activate/deactivate the automatic bypass
regulated by the solenoid valve connected to output EV2,
activated by the input of the pressure switch "P.EV2 input"
Use the buttons and
.
and confirm with
and
Use the buttons
the "unlimited" operating mode to count the hours
worked by the pre-filter.
Access the litre/hour conversion parameter set-up using
.
Use and to change the value and confirm with
.
Press the button to change the pre-filter
operating hours parameter.
Use and to change the value and confirm with
to change of the language setting parameter.
Use
Use and to change the language and confirm with
while connecting the power
to
Enter the menu
.
to select the stored names
to activate or deactivate
Confirm with the button
EN
.
.
-
35
-