Publicidad
Checking the settings on the indoor unit
You can check the setting status of all indoor units connected to this unit in a list. You can also change the
display to show by area.
Note
y Before proceeding with this setting, you must register the area to be displayed and also register indoor units in that area.
After performing "Changing the name of the area group" (P.21 to 22), perform "Basic settings on the indoor unit" (P.18 to 20), and
then proceed with these settings.
1
Touch [Operation/Status] in "Oper./
Status".
1
2
Touch [I/D unit list].
The "I/D unit list" screen is displayed.
z
3
Checking the status of settings.
Refer to P.9 for details about the screen.
z
Note
y You can select indoor units to change their settings. (→ "Operating
the indoor unit" (P.10))
8
Select the area to display
1
2
2
Touch [Area].
The "Select Area" dialogue is displayed.
z
1
Select the area to display.
If 9 or more area groups have been registered (P.21),
z
you can scroll up or down by swiping or flicking the screen.
The "Select Area" dialogue is closed and the settings of the
z
selected area are displayed in the list.
2
Publicidad
