Note: Keep all the parts removed so at to be able to refit the door.
Unplug the appliance from the electrical outlet when reversing the opening
direction of the door.
•
1.
Remove the top hinge cover and then remove the
3 screws holding the top hinge (fig. 1). Remove the
hinge.
2.
Using a flat screwdriver, remove the plastic plug
covering the hinge hole on the opposite side.
3.
Lift the door carefully and place it on a padded
surface so as not to scratch it.
4.
Place the plastic cap (step 2) into the free hole in
the hinge on the opposite side.
5.
Remove the two bolts holding the
lower left hinge (fig. 2).
6.
Unscrew the left foot and remove it.
7.
Unscrew the lower left hinge and
remove it.
8.
Unscrew the right foot and replace it
on the opposite side.
9.
Replace the lower hinge on the
opposite side by slightly tightening the 2 bolts (do
not tighten the bolts until the door is closed and
level) and then screw the foot back on.
10. Replace the door on the lower hinge pin. Place the
door against the refrigerator and check that it is
level, then tighten the bolts completely.
11. Replace the top hinge cover.
V.1.0
Lower hinge
[Fig. 3]
20
Top hinge cover
Screws (x 3)
Upper hinge
[Fig. 1]
Bolt (x 2)
[Fig. 2]
Right foot
Shaft
Left foot