Publicidad
Idiomas disponibles
Idiomas disponibles
FIG.3 BILLIARD TABLE ASSEMBLY
8. Attach two previously-assembled Legs (#4 and #5) to the end of Billiard Cabinet(#1) using
four Bolts (#8) per Leg. See FIG.3.
9. Attach the other two previously-assembled Legs (#4 and #5) to the other end of Billiard
Cabinet(#1) but using only two Bolts (#8) on the sides of each Leg. See FIG.3.
Note: Please do not use any screws on the holes in the end apron of Billiard at this step.
The bolts will be added later for the crooked Pole (#19). See FIG.5A
10. Attach the Leg Side Panel (#6) between the inside of Left and Right Legs using four Screws
(#18) per Leg Side Panel. See FIG.3.
5
8
8
11. Lift the table assembly from the floor
with two strong adults, turn it over,
and set table on its legs in the location
where you play. Go back and make sure
that all connections are tight.
FIG.4 BASKET OF BILLIARD
TABLE ASSEMBLY
12. Attach the Corner Basket (#23)
and Side Basket (#24) to Billiard
Cabinet (#1) using two Screws (#15)
per Basket. See FIG.4
Note: Repeat the steps above for
the other baskets.
CAUTION: Two strong adults are recommended to turn the table over as shown.
1. Lift the table off the ground.
2. Turn the table over.
3. Place it on all four feet at the same time on the ground.
FIG.3
18
4
4
5
6
1
8
HOLD TABLE
5
8
DO NOT LEAN THE
CABINET
DO NOT
TABLE ON ITS LEGS!
HOLD THE
LEGS
Publicidad
