Samsung POWERbot SR1AM70 Serie Manual Del Usuario página 13

Automatic charging
Recharging
Low battery (Lo)
Steps to take if automatic recharging is not occuring:
Reconsider the location of the docking
station when:
the docking station is located in a place where
the POWERbot cannot easily access it.
the distance between the docking station and
POWERbot is over 16.4 ft (5 m).
– It may take a long time for the POWERbot to
return to the docking station for recharging
1. SR1AM7010U
If the battery indicator blinks at 0.4 sec. intervals,
the POWERbot will automatically return to the
docking station to recharge.
2. SR1AM7040W* / SR2AM70**** Series
When the battery indicator blinks during cleaning,
the POWERbot will return to the docking station to
charge itself automatically.
You can command the POWERbot to
recharge at the docking station while it is
cleaning.
You can manually charge the POWERbot by
placing it in the docking station.
Manually charge the POWERbot when:
the docking station is located in a corner
the battery is fully exhausted
the POWERbot is immobilized by an obstacle
(furniture, etc.)
the POWERbot can't climb a threshold near
the docking station (The maximum height of
a threshold the POWERbot can climb is about
0.6 in (1.5 cm)).
the battery indicator blinks and "Lo" is
displayed
the battery indicator blinks (Applicable to
SR1AM7010U* Series)
the POWERbot is set to the Spot clean or
Manual clean mode
ENGLISH-13
Series
*