Samsung POWERbot SR1AM70 Serie Manual Del Usuario página 8

Safety information
Power related
WARNING
To prevent the risk of electric shock or
fire:
– Do not damage the power cord.
– Do not pull the power cord too hard or
touch the power plug with wet hands.
– Use only power sources that provide
between 100 and 240 volts. Do not plug
the POWERbot into a multi-outlet power
strip. Do not place the power cord where it
can be stepped on, tripped over, or where
the POWERbot can run over it.
– Do not use a damaged power plug, power
cord, or loose power outlet.
Clean dust or any foreign matter off the
prongs of the power plug.
– There is a risk of electric shock or
malfunction.
Before use
WARNING
Do not use POWERbot near a heater or
combustible materials.
– Do not use powerbot near fire or flame such
as a movable heater, a candlelight, a desk
lamp, a fireplace etc. or in a place where
combustible materials such as gasoline,
alcohol, thinner etc. exist.
Make sure there are no dangerous objects
around the POWERbot's cleaning area to
prevent collision and unplug any electric
heaters or fans.
The POWERbot is intended for specific
household use. Do not use it in an attic,
basement, storage area, industrial
building, outside, in places with moisture
(such as a bathroom or laundry room), on
a table or on shelves.
– The POWERbot can be damaged or
malfunction.
Be sure the POWERbot does not pass
through or touch any kind of liquid.
– The POWERbot can be severely damaged
and it may contaminate other areas if the
wheels pass through liquid.
Attach the boundary markers to places
where the POWERbot may fall such as
the top of a staircase or a bannister to
prevent product damage and injury.
– Please keep the cliff sensor clean at all
times for safety.
Do not spill any liquid on the docking
station.
– There is a risk of fire or electric shock.
Do not use the docking station for
anything other than its intended purpose.
– There is a risk of fire or severe damage to
the docking station.
Always keep the cliff sensor clean for
your safety.
WARNING
If any abnormal sounds, smells, or smoke
come from POWERbot, immediately shut
off the POWERBOT using the emergency
switch on the bottom of POWERbot, and
then contact a Samsung service center.
WARNING
If the power cord is damaged, contact a
Samsuing service center to get it replaced
by a certified repairman.
– There is a risk of fire or electric shock.
Contact a Samsung Electronics service
center if you need to replace the batteries.
– Using batteries from other products can
cause the POWERbot to malfunction.
CAUTION
If a brush or brush cover is not assembled
correctly, scratches may occur on the
floor, or product malfunction may occur.
Before operating the POWERbot, remove
the objects which could break such as
a frame, mirror, and porcelain items
so that the POWERbot works without
interruption.
ENGLISH-08
In use
Cleaning and
maintenance
Before use