Samsung POWERbot SR1AM70 Serie Manual Del Usuario página 9

Insert the dustbin before using the
POWERbot.
For proper automatic recharging, do the
following:
– Always turn on the power of the docking
station.
– Install the docking station where the
POWERbot can find it easily.
– Do not leave any object in front of the
docking station.
When installing the docking station, do
not leave the cord on the floor where the
POWERbot can run over it.
Do not use POWERbot on black colored
floors.
– The POWERbot may not be able to operate
normally.
Do not place any objects within 1.6 ft
(0.5 m) of either side of the docking
station or within 3.3 ft (1 m) of the front
of the docking station.
Make sure the docking station's charging
contact is not damaged and is free of
foreign matter.
Do not install the docking station in an
area with a dark floor.
– If the floor around the docking station is
dark, recharging is hindered.
Move any obstacles that may disturb
POWERbot's movement (such as a
children's indoor swing or slide) before
cleaning.
Do not use the POWERbot in a place
which is narrower than its turning radius
(1.6 ft/0.5 m or less).
To clean all areas of your house, open all
rooms and attach the boundary markers
to places where the POWERbot could get
damaged such as a front door, veranda,
bathroom, or stairs.
For areas with low clearance where
the POWERbot may get stuck, attach
the boundary markers to prevent the
POWERbot from getting in.
CAUTION
Using the POWERbot on thick carpet may
damage both the POWERbot and the
carpet.
– The POWERbot cannot pass over carpet that
is thicker than 0.4 in (1 cm).
Do not use the POWERbot on tables or
other high surfaces.
– There is a risk of damage if it falls.
The POWERbot may bump into chair or
desk legs. Move them out of the away for
faster, more efficient cleaning.
When the POWERbot is operating, do not
lift it up or carry it to another area.
Do not hold the POWERbot by its driving
wheels when carrying it to another area.
Do not put any objects on top of the
POWERbot and camera since this may
cause the POWERbot to malfunction.
Remove any large pieces of paper or
plastic bags from the area to be cleaned
before using the POWERbot since they
may block the POWERbot's intake.
Do not aim the red pointer directly at
people or animals.
Do not lie down near the POWERBOT
when it is running.
– Your hair may be caught in the brush,
resulting in physical injury.
CAUTION
To prevent any damage to the POWERbot:
– Do not clean the POWERbot by spraying
water directly onto it or using benzene,
thinner, acetone or alcohol to clean it.
Do not disassemble or try to repair the
POWERbot yourself. Repairs should only
be done by a certified repairman.
Always keep the obstacle sensor, cliff
sensor, and camera clean.
– If foreign matter accumulates, the sensors
may malfunction.
ENGLISH-09
In use
Cleaning and
maintenance