Vornado VFAN Manual De Instrucciones página 10

GRILL REMOVAL
WARNING: To avoid risk of fire, electrical shock, or injury to persons, unplug
the Air Circulator before removing the grill.
To protect paint, apply masking tape over the head of a flat screwdriver and
up to about 2 inches on the screwdriver shaft. Place flat screwdriver against the
angled section of the grill support tab, (as shown) and press outward to allow
the grill wire to be released from the support tab. Repeat on second and third
grill support tab. To reinstall, relocate grill wire ends into the support tabs,
use the flat screwdriver to flex back the support tabs to allow grill to snap into
place. Be sure all three grill wire ends are engaged.
10 English
BLADE REMOVAL
WARNING: To avoid risk of fire, electrical shock, or injury to persons, make
sure the Air Circulator is still unplugged before removing the blade.
It is possible to remove the blade should something accidentally get wrapped
around the motor shaft. Once the grill is removed (see GRILL REMOVAL sec-
tion) pull the blade straight out from the shaft. When replacing, the blade can
only go on the shaft one way. Push the blade all the way on the shaft until it
bottoms out. Do not use a hammer as this could result in bearing damage.