Silvercrest SDBB 2400 A1 Instrucciones De Uso página 17

3) Mix 150 ml of tap water with 150 ml of descaling agent (ratio 1:1) and
pour the mixture into the water tank.
4) Allow the solution to work for approx. 30 minutes.
5) Hold the steam iron horizontally over a sink or suitable container.
6) Press and hold down the self clean button
and forth a little so that the contents of the water tank come out of the steam
holes of the soleplate
7) Release the self clean button
out of the steam holes on the soleplate
the remaining contents of the water tank completely into a sink via the filler
opening
NOTE
► After descaling the steam iron, always carry out two rinsing cycles using the
self clean button
thoroughly rinsing the water tank with tap water.
8) Use the measuring cup
tap water and repeat steps 5 to 7 twice. To rinse the water tank thoroughly,
use only tap water for the two rinses.
Storage
■ Store the cooled-down appliance in a clean, dust-free and dry location.
Troubleshooting
Problem
The steam iron blasts
out no steam/very
little steam.
The steam iron does
not get hot.
The steam iron cannot
be switched on.
■ 14 │ GB │ IE
0
.
q
2
.
q
. Do not use a descaling agent without subsequently
w
to fill the water tank up to the MAX marking with
Cause
The steam iron's wa-
ter tank is empty.
Limescale deposits
reduce the steam
output.
The steam iron is not
plugged in or is not
switched on.
The steam iron is
defective.
q
. Move the steam iron back
as soon as the amount of water flowing
0
becomes noticeably less. Empty
Solution
Fill the water tank with tap
water (See section Filling
the water tank).
Descale the steam iron (see
section Descaling the
steam iron).
Insert the plug into a wall
power socket and adjust the
temperature control
desired ironing temperature.
Have the steam iron repaired
by a qualified technician (see
section Service).
6
to the
SDBB 2400 A1