EN
Environmental protection
Saving Energy
This appliance is energy-efficient but there are
some tips on how to save even more energy:
• During cooking, ensure that there is a
sufficient supply of air to enable the extractor
hood to work efficiently and with a low level
of operating noise.
• Adjust the fan speed to the amount of of
steam produced during cooking. Only use
intensive mode when required. The lower the
fan speed, the less energy is consumed.
• If cooking produces large amounts of steam,
select the higher fan speed in good time. If
the cooking steam has already spread
around the kitchen, the extractor hood will
need to be operated for longer thus
consuming more energy.
• Switch off the extractor hood if you no longer
require it.
• Switch off the lighting if you no longer require
it.
• Clean and (if required) replace the filter at
regular
intervals
effectiveness of the ventilation system and to
prevent the risk of fire.
• Put the lid on pans to reduce cooking steam
and condensation.
Disposal of the packaging
The packaging bears the Green Point mark.
Dispose of all the packaging materials such as
cardboard, expanded polystyrene and plastic
to
increase
the
wrapping in the appropriate bins. In this way you
can be sure that the packaging materials will be
re-used.
Dismantling the equipment:
1. Disconnect the mains power.
2. Remove the duct cover above the hood.
3. Disconnect the duct.
4. Supporting the equipment, remove the srews
that fix it to the wall.
5. For waste disposal, proceed according to the
appropriate
guidelines.
Disposal of equipment no longer used
According to European Directive 2012/19/EU on
the
management
electronic equipment (WEEE), home electrical
appliances should not be put into the normal
systems for disposal of solid urban waste.
Outdated
appliances
separately
to
recovery and re-cycling rates and to prevent
potential harm to human health and the
environment. The symbol of a rubbish container
superimposed by a diagonal cross should be put
on all such products to remind people of their
obligation
to
separately.
Consumers should contact their local authorities
or point of sale and request information on the
appropriate places to leave their old home
electrical appliances.
Before disposing of your appliance, render it non-
usable by pulling out the power cable, cutting this
and disposing of it.
22
environmental
of
waste
electrical
should
be
optimize
component
have
such
items
protection
and
collected
material
collected