Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
Cleaning and maintenance
CLEANING
WARNING!
-
Never use steam cleaning equipment.
-
Only clean the oven when it is cool to the touch.
-
Disconnect the appliance from the power supply.
Oven exterior
IMPORTANT: do not use corrosive or abrasive
i
detergents. If any of these products accidentally
comes into contact with the appliance, clean immediately
with a damp cloth.
•
Clean the surfaces with a damp cloth. If it is very dirty,
add a few drops of washing up detergent to the
water. Finish off with a dry cloth.
Oven interior
IMPORTANT: do not use abrasive sponges or
i
metallic scrapers or scourers. Over time, these can
ruin enamelled surfaces and the oven door glass.
•
After every use, allow the oven to cool then clean it
preferably while it is still warm in order to remove
built-up dirt and stains caused by food residues (e.g.
food with a high sugar content).
•
Use proper oven detergents and follow the
manufacturer's instructions to the letter.
•
Clean the door glass with a suitable liquid detergent.
The oven door can be removed to facilitate cleaning
(see MAINTENANCE). Inner glass is smooth to
facilitate cleaning.
NOTE: during prolonged cooking of foods with a high
water content (e.g. pizza, vegetables, etc.) condensation
may form on the inside of the door and around the seal.
When the oven is cold, dry the inside of the door with a
cloth or sponge.
Accessories
•
Soak the accessories in water with washing up
detergent immediately after use, handling them with
oven gloves if still hot.
•
Food residues can be easily removed using a brush or
sponge.
Maintenance
WARNING!
-
Use safety gloves.
-
Ensure the oven is cold before carrying out the
following operations.
-
Disconnect the oven from the power supply.
To remove the shelf guides
firmly grip the external part of the guide, and pull it
towards you to extract the support and the two internal
pins from the lodging.
To reposition the shelf guides
position them near the cavity and initially insert the two
pins into their lodgings. Next, position the external part
near its lodging, insert the support, and firmly press
towards the wall of the cavity to make sure the shelf
guide is properly secured.
To remove the door
1. Open the door fully.
2. Lift the catches and push them forwards as far as they
will go (Fig. 1).
3. Close the door as far as it will go (A), lift it up (B) and
turn it (C) until it is released (D) (Fig. 2, 3, 4).
To refit the door
1. Insert the hinges in their seats.
2. Open the door fully.
3. Lower the two catches.
4. Close the door
Fig. 1
Fig. 2
Fig. 3
Fig. 4
20
Publicidad
