Medisana HP 630 Manual De Instrucciones página 29

•
2.3 Operating
Make sure, the connection cable of the control unit is properly connected to the plug of
the heat pad. Plug the unit into the mains outlet and move the slider control from
position 0 to position 1. The power LED will light up in orange (warm up phase) and
after reaching the final temperature level it will light up in green.
minutes you will be able to feel the pad getting noticeably warmer. If you require a
higher temperature setting, move the switch to the next positions 2 or 3 or the
maximum heat setting, position 4. If the heat pad gets too hot for you, move the slider
back to position 3, 2 or 1. After a short time, the heat pad will cool down. The heat pad
has an accurate electronic control system. Depending on the room temperature, the
LED may change from orange to green colour and back within seconds. This
indicates the fast re-heating and is normal.
To switch the unit off, move the switch back to position 0. The power LED will go out,
indicating that the unit is switched off. Unplug the unit from the mains outlet. Move the
switch to position 1 for any continuous use. The heat pad will switch off automatically
after approx. 90 minutes of continuous use. To switch it back on again, move the
slider switch to position 0 and then back to the desired heat setting. Unplug the unit
from the mains outlet once you have finished using it.
The particular shape is especially designed for use on shoulders, neck and back.
Using the heat pad stimulates blood circulation in hardened muscles and
helps you to relax after a strenuous day.
The heat pad features an electric temperature control that regulates the temperature
according to the chosen setting. The two snap buttons on the front part and the
practical belt keep the heat pad for shoulders and back HP 630 in ist position.
3 Miscellaneous
3.1 Troubleshooting
This unit is equipped with the active protection system APS TECH. The unit
detects different causes of errors and emits corresponding alarm sounds if
necessary. In the case of an error, the power LED will light up in red.
G
3 beeps in 1-second interval and power LED lights up in red:
The connection cable of the control unit is not properly connected to the heat pad
or another electrical defect is present. Please check the cable connection. Is the
cable connected properly, please do not use the heat pad and contact the service
center.
3 beeps in 2-second interval for one minute and power LED lights up in red:
The heat pad is broken, folded or fully covered. Please use the heat pad only
according to this instruction manual and pay attention to all points in the safety
GB
G After a few
G
23