Publicidad
Idiomas disponibles
Idiomas disponibles
Change the power cord
Position A show the terminal box position on the back of the back outer case and it's
closed.
Steps: a. cut off the power, use small f at screwdriver to open two snap 1，2.
b. use Phillips crewdriver to take off screws 3，4 ，5and6.
c. change the new power cord ,f x the yellow/green wire on 3，brother wire on 4，
blue wire on 5.
d. twist screw 6 closed the terminal box cover f nish the changing.
A
back outer case
CURE YOUR APPLIANCE WHEN NEEDED
If a fault occurs, before calling the after-sales service, please ensure that is not because
of incorrect operations and refer to the fault table, attempt to correct the fault yourself.
You can often easily rectify technical faults on the appliance yourself.
If a dish does not turn out exactly as you wanted, you can find many tips and instruc
tions for preparation at the end of the operating manual.
Fault
Possible Cause
Faulty fuse.
The appliance
does not work.
Power cut
Knobs have
Knobs have
been acci-
fallen out of the
dentally
support in the
disengaged.
control panel.
brown {L}
yellow/green
power cord
blue {N}
Notes/remedy
Check the circuit breaker in the fuse box.
Check whether the kitchen light or other kitchen
appliances are working.
Knobs can be removed.
Simply place knobs back in their support in the
control panel and push them in so that they engage
and can be turned as usual.
31
4
3
1 2
5
6
terminal box
Publicidad
