Metabo TDP 7501 S Manual Original página 14

ENGLISH
Motor hums, but does not start:
Pump blocked by foreign objects.

– Clean impeller.
Pump runs, but does not pump properly:
Delivery head too high.

– Observe max delivery head (see 'Tech-
nical Specifications').
Discharge hose kinked.

– Straighten discharge hose.
Discharge hose leaky.

– Seal discharge hose; tighten screw fit-
tings.
Non-return valve incorrectly installed.

Pump runs very noisily:
Pump is sucking air.

– Ensure there is a sufficient water sup-
ply.
– Foreign objects are present (clean
pump).
– Manual mode has been set (shallow
water suctioning).
– Hold pump at an angle when submerg-
ing.
Pump runs continuously:
Float switch does not reach cut-out posi-

tion.
– Make sure the float switch can move
unrestrictedly.
8. Repairs
A
Danger!
Repair of power tools must be carried out by
qualified electricians only!
Power tools in need of repair can be sent to
the service centre in your country. Refer to
spare parts list for address.
Please attach a description of the fault to the
power tool.
9. Disposal
Power tools do not belong in the
household rubbish. According to
European
Directive 2002/96/EC on waste
electrical and electronic
equipment, electrical waste must
be collected separately and taken
to an environmentally friendly recycling facili-
ty.
14
Contact your local council for information on
disposal of the used tool.
All packaging materials are recyclable.