LUND 67522 Manual De Instrucciones página 10

GB
humidity must be below 90% without condensation.
Recommendations for connecting the appliance to the power supply
Before connecting the appliance to the power supply, make sure that the voltage, frequency
and performance of the power supply corresponds to the values shown on the appliance's
rating plate. The plug must fi t into the outlet. It is forbidden to modify the plug in any way.The
appliance must be connected directly to a single power supply socket. It is forbidden to use
extension cords, adapters or double sockets. The power supply circuit must be fi tted with a
protective conductor and at least a 16 A protective device. Avoid contact of the power cord
with sharp edges, hot objects or surfaces. During operation, the power cord must always be
fully extended and the position of the power cord must be set so that it does not become an
obstacle during operation. The power cord shall not be placed a manner that would pose a
risk of tripping. The power supply socket should be located in a place where it is always pos-
sible to quickly remove the appliance power cord plug. Always pull the power cord by the plug
housing when unplugging it, never by the cord. If the power cord or the plug are damaged,
immediately disconnect it from the power supply and contact an authorised service centre of
the manufacturer for replacement. Do not use the appliance with a damaged power cord or
plug. The power cord or plug cannot be repaired and must be replaced with a new one that is
free of defects if these components are damaged. Replacement of the power cord and plug
must be carried out by an authorised service centre of the manufacturer.
Instructions for the use of the appliance
WARNING! The cooktop surface can be hot after use. Do not touch it, as it may cause se-
vere burns. Allow the cooktop to cool down. When preparing dishes which may spread hot
food fragments, personal protective equipment should be worn to protect from burns. Make
sure that the fl oor near the appliance is not slippery. This will prevent slipping, which can
cause serious injuries. Observe the food at all times and prevent it from burning during its
preparation. Food left unattended can burn, which can cause fi re and serious burns. When
preparing dishes, touch the cooktop surface only with utensils made of wood or plastic. The
utensils should be able to withstand the temperature generated by the cooktop. It is forbidden
to remove and distribute food using hands. If any food is left on the cooktop during or after
preparation, remove the food remains before preparing another dish. Food remains can be
burned, causing smoke, unpleasant smell, and aff ect the taste of the prepared food. They
may also be the cause of fi re. Use utensils made of wood or plastic able withstand the tem-
perature generated by the cooktop. Do not use sharp or metal utensils. Such utensils can
damage the cooktop surface. If the preparation of a dish requires the use of oil, spread it on
the surface of the cooktop with a soft brush. The appliance is not used for preparing dishes
by deep-frying.
APPLIANCE OPERATION
Installation, start-up and operation of the appliance
The appliance must be unpacked and all parts of the packaging completely removed. It is recommended to keep the packaging,
as it can be helpful for further transport and storage of the appliance.
Prepare the appliance according to the instructions specifi ed in the "Product Maintenance" section.
O R I G I N A L I N S T R U C T I O N S
10