Silvercrest STWSK 3 A1 Instrucciones De Servicio página 41

• To switch off both earphones 1/6 outside the charging
box 12, press and hold one of the multifunction buttons 2/5
for approx. 5 seconds until an acoustic signal is heard.
7.2 Connecting the earphones to the audio
device
The two earphones 1/6 are connected to each other and to the
audio device via Bluetooth. TWS (True Wireless Stereo) enables
stereo playback without a cable connection.
NOTES:
• In order for the TWS connection to be established between
the two earphones, the left earphone 1 must not be already
connected to the audio device (or another Bluetooth device
nearby) beforehand.
• If you encounter problems establishing the connection, pro-
ceed as described in the section "No connection to the
audio device" on page 40.
• The connection to the audio device is established with the
right earphone 6.
• Please note that the establishment of the connection may
vary slightly depending on the device and the software
used.
1. Remove the earphones 1/6 from the charging box 12.
These are automatically switched on and connected to
each other via TWS. Then the LED 4 of the right earphone
starts flashing red/white while the connection to the audio
device is being established. The earphone now transmits
the identification. The LED of the left earphone flashes
white.
2. Place the left earphone 1 in your left ear, the right ear-
phone 6 in your right ear.
3. If necessary, start the Bluetooth connection on the audio
device (e.g. smartphone, MP3 player). The audio device
should now receive the device identifier STWSK 3 A1.
39
GB