Publicidad
(III) How to operate K glue binding machine
A. Get ready
(III) How to operate K glue binding machine
1) Make sure that the transportation fixing plate removed.
A、 、 Get ready
2) Clean antirust agent one cover clamping table and so on (where the paper may touch).
1)
Make sure that the transportation fixing plate removed.
3) Plug in, turn on power and emergency stop. On screen display WARMING UP, machine works normal
2)
Clean antirust agent one cover clamping table and so on (where the paper may touch).
4) Make sure set up correct temperature, mode and so on. Note: different temperature for different type of glue.
3)
Plug in, turn on power and emergency stop. On screen display WARMING UP, machine works normal
5) The glue get melt within about 35 min.
4)
Make sure set up correct temperature, mode and so on. Note: different temperature for different type of glue.
5)
The glue get melt within about 35 min.
6) When set up temperature, the buzzer sounds "di,di", on the screen also display reminding words
6)
When reach set up temperature, the buzzer sounds "di,di", on the screen also display reminding
7) The glue must completely melt. If bubble appears, increase temperature or add more glue.
words
8) According to your own skill to choose Mode 1, 2, or 3.
7)
The glue must completely melt. If bubble appears, increase temperature or add more glue.
Reminding: The glue won't rotate until the temperature reach set up value. The machine is on, and don't use is for long
8)
According to your own skill to choose Mode 1, 2, or 3.
time (for example 1hour or longer), please switch to warm keeping mode or turn off machine to avoid glue aging.
(III) Cómo operar las fresadoras encoladoras de la serie K
Reminding
The glue won't rotate until the temperature reach set up value.
A. Prepárate
The machine is on, and don't use is for long time (for example 1hour or longer), please switch to
1) Asegúrese de quitar la placa de fijación de transporte.
warm keeping mode or turn off machine to avoid glue aging.
2) Limpie la mesa de sujeción de una cubierta con agente antioxidante y así sucesivamente (donde el papel pueda tocar).
3) Enchufe, encienda y pare de emergencia. Visualización en pantalla
4) Asegúrese de configurar la temperatura, el modo, etc. correctos. Nota: diferente temperatura para diferentes tipos de pegamento.
5) El pegamento se derrite en aproximadamente 35 min.
6) Cuando se configura la temperatura, el zumbador suena "di, di", en la pantalla también se muestran palabras recordatorias
Recordando: El pegamento no girará hasta que la temperatura alcance el valor establecido.
Si la máquina está encendida y no debe usarse durante mucho tiempo (por ejemplo, 1 hora o más), cambie al modo de mantenimiento en caliente o
apague la máquina para evitar el envejecimiento del pegamento.
WARMING UP
(CALENTANDO), la máquina funciona normalmente
- 18 -
Publicidad
