Descargar Imprimir esta página

EINHELL TE-PL 900 Manual De Instrucciones página 30

Ocultar thumbs Ver también para TE-PL 900:

Publicidad

Idiomas disponibles

Idiomas disponibles

new knives when worn down.
Some types of planing knives have two bla-
des. When one blade has become blunt, the
planing knife can be turned over.
Blunt planing knives cannot be resharpened.
Always ensure that you replace both knives at
the same time.
Only the original, manufacturer-approved
knife block may be used for this electric hand
plane.
Always use only clean and sharp planing kni-
ves to ensure professional, safe results.
Do not lose these safety regulations.
2. Layout and items supplied
2.1 Layout (Fig. 1/2/3)
1. Setting knob for the chip depth
2. Parallel stop
3. Safety lock-o
4. ON/OFF switch
5. Rear base plate
6. Belt cover
7. Adapter for chip ejector
8. Front base plate
9. Storage compartment for accessories
10. Mount for chip ejector adapter
11. Thumb screw for step depth scale
12. Step depth scale
2.2 Items supplied
Please check that the article is complete as
specified in the scope of delivery. If parts are
missing, please contact our service center or the
sales outlet where you made bought the product
within the maximum days indicated by the con-
sumer protection laws of your country and upon
presentation of a valid bill of purchase. Also, refer
to the warranty table in the service information at
the end of the operating instructions.
Open the packaging and take out the equip-
ment with care.
Remove the packaging material and any
packaging and/or transportation braces (if
available).
Check to see if all items are supplied.
Inspect the equipment and accessories for
transport damage.
If possible, please keep the packaging until
the end of the guarantee period.
Anl_SA_TE_PL_900_SPK8.indb 30
Anl_SA_TE_PL_900_SPK8.indb 30
GB
Danger!
The equipment and packaging material are
not toys. Do not let children play with plastic
bags, foils or small parts. There is a danger of
swallowing or suffocating!
Hand-held electric plane
Parallel stop
Wrench
Step depth scale
Original operating instructions
3. Proper use
The hand-held electric plane is designed for pla-
ning, rabating and chamfering pieces of wood.
The equipment is to be used only for its prescri-
bed purpose. Any other use is deemed to be a
case of misuse. The user / operator and not the
manufacturer will be liable for any damage or inju-
ries of any kind caused as a result of this.
Please note that our equipment has not been de-
signed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
4. Technical data
See warranty card of your country.
Sound and vibration
Sound and vibration values were measured in
accordance with EN 62841.
Wear ear-muffs.
The impact of noise can cause damage to hea-
ring.
Total vibration values (vector sum of three direc-
tions) determined in accordance with EN 62841.
Warning!
The specified vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equip-
ment is used and may exceed the specified value
in exceptional circumstances.
The specified vibration value can be used to
compare the equipment with other electric power
tools.
- 30 -
12.10.2020 15:00:07
12.10.2020 15:00:07

Publicidad

loading