Publicidad
STeP 14:
(See FIGure 14)
• Attach the wheel (17) to the wheel mount bracket (16)
using a hex bolt (E), two washers (W), a hex nut (Q),
and a Nylock hex nut (O).
• Tighten, but not too tight. The wheel should rotate
easily.
O
16
Q
W
17
W
E
FIGure 14
oPeraTIon
cauTIon: Failure to obey the following
cautions could result in personal injury
or product damage:
• Securely position your feet on the
push tube handles when engaging or
disengaging the dethatcher.
• Do noT take your feet off the push
tube handles until the dethatcher is
either fully locked into the disengage
position or fully released to the engage
position.
• Do noT allow the dethatcher to fall
over when upright.
Take care when operating your dethatcher. Operating
your dethatcher according to these instructions will help
prevent damage and prolong the life of your dethatcher.
• Refer to the vehicle owners manual for instructions on
safe operation on slopes.
• The maximum pushing speed for this dethatcher
assembly is 7 m.p.h.
• Watch out for exposed tree roots, as they can cause
damage to the dethatcher.
• For best results, always mow the grass to an even
height before using the dethatcher.
11
Publicidad
