Publicidad
aTTach The BuLKheaD To The BLaDe
MounT aSSeMBLY
STeP 5:
(See FIGure 5)
• Insert the pivot shaft (8) through the two sets of pivot
brackets (5) of the blade mount assembly (7) and the
holes in the bulkhead (9).
noTe: The holes to use in the bulkhead are determined
by your tractor height.
• Secure each end of the pivot shaft (8) using a
washer (Y) and a hair cotter pin (K).
K
5
7
9
8
Y
K
FIGure 5
aTTach PuSh TuBeS To The BuLKheaD
STeP 6:
(See FIGure 6)
• With a push tube (1) level to the hitch mount assembly
(6), insert the uncapped end of the push tube into the
bulkhead (9) hole at that height.
• Repeat with the second push tube (1).
• Secure each push tube (1) to the bulkhead (9) using a
washer (Y) and hair cotter pin (K).
Y
1
7
9
K
1
6
FIGure 6
Y
K
1
Publicidad
