Publicidad
STeP 7:
(See FIGure 7)
• Attach the two push tubes (1) together using a clevis
pin (H) and a spacer (R) between the push tubes at
the end closest to the bulkhead (9).
• Insert a second clevis pin (H) through the opposite
side of the push tubes at the end furthest from the
bulkhead (9).
• Secure each clevis pin using a hair cotter pin (J).
note: We recommend the two hair cotter pins (P) be on
opposite sides of the push tubes (1).
H
H
R
J
9
J
H
R
FIGure 7
aSSeMBLe SQuare TuBe To BuLKheaD
STeP 8:
(See FIGure 8)
• Attach the square tube (13) to the bulkhead (9) using
two hex bolts (F), washers (X) and hex nuts (M).
• Insert the two square plugs (Z) into the square tube.
M
13
Z
aTTach MounTInG BracKeTS
STeP 9:
(See FIGure 9)
• Attach mounting brackets (11) to the square tube (13)
using two U-bolts (10).
• Secure the U-bolts with four washers (U) and four hex
nuts (P).
10
8
9
X
FIGure 8
13
11
U
P
FIGure 9
F
Publicidad
